P2769 Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)
Diagnostic trouble codes · Vehicles built from Aug 2005
Also covers:
- P2770 Open in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)
DESCRIPTION
Shift solenoid valve SL is turned ON and OFF by signals from the ECM to control the hydraulic pressure in the lock-up relay valve, which then controls the operation of the lock-up clutch.Fail-safe function:
- If the ECM detects a malfunction, it turns shift solenoid valve SL OFF.
- The system cannot control the lock-up relay valve. (No relation to 3-4 shift control)
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P2769 |
ECM detects short in solenoid valve SL circuit when solenoid valve SL operated. (Solenoid resistance: 8 Ω or less) (2-trip detection logic) |
|
| P2770 |
ECM detects open in solenoid valve SL circuit when solenoid valve SL not operated. (Solenoid resistance: 100 kΩ or more) (2-trip detection logic) |
|
MONITOR DESCRIPTION
Based on the signals from the throttle position sensor, the mass airflow meter and the crankshaft position sensor, the ECM sends a signal to shift solenoid valve SL to regulate the hydraulic pressure and provide smoother gearshifting. Shift solenoid valve SL responds to the signals from the ECM. The valve controls the lock-up relay valve to perform the torque converter lock-up function. If the ECM detects an open or short circuit of shift solenoid valve SL, it illuminates the MIL and sets a DTC.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL) |
Disconnect the transmission wire connector from the transaxle.

Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
4 (SL) - Body ground
11 to 15 Ω at 20°C (68°F)
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
Connect the transmission connector to the transaxle.

Disconnect the ECM connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
57 (SL) - Body ground
11 to 15 Ω at 20°C (68°F)
|
|
||||
| OK | ||
| ||
| 3. INSPECT SHIFT SOLENOID VALVE SL |
Remove shift solenoid valve SL.

Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
Solenoid Connector (SL) - Solenoid Body (SL)
11 to 15 Ω at 20°C (68°F)
Connect the positive (+) lead to the terminal of the solenoid connector and the negative (-) lead to the solenoid body to check the solenoid valve operation.
- OK:
- The solenoid makes operating sounds.
|
|
||||
| OK | ||
| ||
