2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

Air Conditioning Control Panel does not Operate

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

This circuit consists of the air conditioning control assembly and the air conditioning amplifier. When the air conditioning control assembly is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the air conditioning control assembly is operated.

WIRING DIAGRAM

E120289E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL ASSEMBLY - BODY GROUND)
E120881E01
  1. Disconnect the air conditioning control assembly connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E16-2 (GND) - Body ground
    Below 1 Ω

  1. Reconnect the air conditioning control assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL ASSEMBLY - IG CIRCUIT)
E120881E02
  1. Disconnect the E16 air conditioning control assembly connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E16-2 (GND) - E16-5 (IG+)
    Ignition Switch on (IG)
    10 to 14 V

  1. Reconnect the air conditioning control assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - AIR CONDITIONING CONTROL)
E115932E03
  1. Disconnect the E16 air conditioning control assembly connector.

  1. Disconnect the E11 air conditioning amplifier connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E11-37 (LIN1) - E16-3 (LIN1)
    Below 1 Ω

  1. Reconnect the air conditioning control assembly connector.

  1. Reconnect the air conditioning amplifier connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. REPLACE AIR CONDITIONING CONTROL ASSEMBLY
  1. Replace the air conditioning control assembly with a new or properly functioning one.

  1. Operate the air conditioning control assembly to check that it functions properly.

    Result:
    Result
    Proceed to
    Air conditioning control assembly malfunctions
    A
    Air conditioning control assembly functions properly
    B



B
END (AIR CONDITIONING CONTROL ASSEMBLY FUNCTIONS PROPERLY)
A

REPLACE AIR CONDITIONING AMPLIFIER


← B1499/99 Multiplex Communication Circuit (from Aug 2005)Blower Motor Circuit (from Aug 2005) →