2005-2008 Yaris · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for LHD)

B118049E01
  1. Check the resistance of the door lock switch.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      w/ Rear power window:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      LOCK
      Below 1 Ω
      -
      OFF
      10 kΩ or higher
      1 - 9
      UNLOCK
      Below 1 Ω

      If the result is not as specified, replace the power window regulator master switch.

      Standard Resistance:
      w/o Rear power window (w/ Jam protection function):
      Tester Connection
      Switch Condition
      Specified Condition
      3 - 7
      LOCK
      Below 1 Ω
      -
      OFF
      10 kΩ or higher
      7 - 9
      UNLOCK
      Below 1 Ω

      If the result is not as specified, replace the power window regulator master switch.

      Standard Resistance:
      w/o Rear power window (w/o Jam protection function):
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 7
      LOCK
      Below 1 Ω
      -
      OFF
      10 kΩ or higher
      7 - 9
      UNLOCK
      Below 1 Ω

      If the result is not as specified, replace the power window regulator master switch.


INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for RHD)

B118050E01
  1. Check the resistance of the door lock switch.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      w/ Rear power window:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 9
      LOCK
      Below 1 Ω
      -
      OFF
      10 kΩ or higher
      8 - 9
      UNLOCK
      Below 1 Ω

      If the result is not as specified, replace the power window regulator master switch.

      Standard Resistance:
      w/o Rear power window (w/ Jam protection function):
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 7
      LOCK
      Below 1 Ω
      -
      OFF
      10 kΩ or higher
      3 - 7
      UNLOCK
      Below 1 Ω

      If the result is not as specified, replace the power window regulator master switch.

      Standard Resistance:
      w/o Rear power window (w/o Jam protection function):
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 7
      LOCK
      Below 1 Ω
      -
      OFF
      10 kΩ or higher
      7 - 9
      UNLOCK
      Below 1 Ω

      If the result is not as specified, replace the power window regulator master switch.

← REMOVAL (from Aug 2005)INSTALLATION (from Aug 2005) →