REMOVAL
Removal / installation · Vehicles built from Aug 2005
| 1.
REMOVE TRANSMITTER BATTERY |
 |
- NOTICE:
- Special caution should be taken for handling components as they are precision electronic ones.
for Europe:
Remove the transmitter battery.
Remove the screw and the cover.
- NOTICE:
- Do not pry out the cover forcibly.
- HINT:
- Slide the cover with a finger as shown in the illustration, so that there should be a small gap, then remove the cover through the gap.
Remove the door control transmitter module.
- Pull out the battery cover.
- Remove the battery (lithium battery: CR1616) as shown in the illustration.
- NOTICE:
- Do not push the terminals with a finger.
- If prying up the battery (lithium battery: CR1616) forcibly to remove, the terminals are deformed.
- except for Europe:
Remove the transmitter battery.
Using a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover.
- NOTICE:
- Do not use excessive force when prying apart the housing cover.
- Remove the door control transmitter module from the transmitter housing case.
- Disengage the hook and remove the transmitter battery cover.
- Remove the battery (lithium battery: CR2016).
- NOTICE:
- Do not push the terminals with your finger.
- Do not use excessive force when prying up the battery (lithium battery: CR2016) as this may damage the terminals.
- Do not touch the battery with wet hands. Water may cause rust.
- Do not touch or move any components inside the transmitter as this may interfere with its proper operation.