2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL EXHAUST PIPE ASSEMBLY TAIL

  1. Install the 2 exhaust pipe support No. 4 and the exhaust tail pipe assembly.

    A115440


2. INSTALL EXHAUST PIPE ASSEMBLY FRONT

A104634
  1. Using vernier calipers, measure the free length of the compression spring.

    Minimum length (Front Side):
    40.5 mm (1.594 in.)
    Minimum length (Rear Side):
    38.5 mm (1.516 in.)

    If the length is not as specified, replace the compression spring.

  1. A104635E01
    Using a plastic hammer and a wooden block, tap in a new exhaust pipe gasket until its surface is flush with the exhaust manifold.

    NOTICE:
    1. Install the exhaust pipe gasket in the correct direction.
    2. Do not damage the outer surface of the exhaust pipe gasket.
    3. Do not reuse the exhaust pipe gasket.
    4. Do not push in the gasket with the exhaust pipe when connecting it.

  1. Install the 3 exhaust pipe support No. 4.

  1. Install the exhaust front pipe assembly and a new exhaust pipe gasket with the 4 compression springs and 4 bolts.

    A115439

    Torque:
    43 N*m{ 439 kgf*cm , 32 ft.*lbf }


3. INSTALL HEATED OXYGEN SENSOR

A115451
  1. Using SST, install the sensor onto the front exhaust pipe.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

  1. A115450
    Connect the sensor connector and engage the 3 clamps.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


5. CHECK FOR EXHAUST GAS LEAKAGE
← REMOVAL (from Aug 2005)COMPONENTS (from Nov 2005) →