2005-2008 Yaris · Service Manual BRAKE

C1246/46 Master Cylinder Pressure Sensor Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

Also covers:

DESCRIPTION

The master cylinder pressure sensor is connected to the skid control ECU in the ABS and TRACTION actuator.
DTC C1281/81 is deleted when the master cylinder pressure sensor sends a master cylinder pressure signal or test mode ends.
DTC C1281/81 is output only in test mode.
DTC No.
DTC Detecting Conditions
Trouble Areas
C1246/46
When any of following conditions detected:
  1. Despite stop light switch signal being off, master cylinder pressure 10 bars (1000 kPa) or more for 8 minutes or more
  2. Malfunction in master cylinder pressure sensor or its circuit
  3. When stop light switch off, master cylinder pressure changes by 500 bars (50000 kPa) or more
  1. Master cylinder pressure sensor
  2. Master cylinder pressure sensor circuit
  3. Stop light switch circuit
  4. ABS and TRACTION actuator
C1281/81
Detected only during test mode.
  1. Master cylinder pressure sensor
  2. Master cylinder pressure sensor circuit
  3. Stop light switch circuit
  4. ABS and TRACTION actuator

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. READ VALUE OF DATA LIST (STOP LIGHT SWITCH)

  1. A107926E08
    Connect the intelligent tester to the DLC3.

  1. Turn the tester on.

  1. Select the DATA LIST mode on the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Data List.

    DATA LIST: ABS/VSC/TRC 
    Item (Display)
    Measurement Item : Range (Display)
    Normal Condition
    Stop Lamp SW
    Stop light switch : ON or OFF
    ON: Brake pedal applied
    OFF: Brake pedal released

  1. Check that "Stop Lamp SW" turns ON and OFF when the brake pedal is depressed and released.

    OK:
    "Stop Lamp SW" turns ON and OFF in accordance with the operation of the brake pedal.



NG
CHECK STOP LIGHT SWITCH CIRCUIT
OK


2. READ VALUE OF DATA LIST (MASTER CYLINDER PRESSURE SENSOR)

  1. A107926E08
    Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Turn the tester on.

  1. Read the output voltage of the master cylinder pressure sensor using the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Data List.

    DATA LIST: ABS/VSC/TRC 
    Item (Display)
    Measurement Item : Range (Display)
    Normal Condition
    Master Cylinder Sensor
    Master cylinder pressure sensor 1 reading : min.: 0 V, max.: 5 V
    When brake pedal released: 0.3 to 0.9 V

  1. Check that the master cylinder pressure sensor reading increases when the brake pedal is depressed.

    OK:
    The sensor output voltage increases.



NG
REPLACE ABS AND TRACTION ACTUATOR
OK


3. RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Drive the vehicle at a speed of 30 km/h (18 mph) or more and perform a braking test (decelerate the vehicle by depressing the brake pedal).

  1. Check if the same DTC(s) is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C1241/41 Low Battery Positive Voltage or Abnormally High Battery Positive Voltage (from Nov 2005)C1249/49 Open in Stop Light Switch Circuit (from Nov 2005) →