2005-2008 Yaris · Service Manual BRAKE

C1241/41 Low Battery Positive Voltage or Abnormally High Battery Positive Voltage

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

When there is an abnormality in the power supply circuit of the ABS and TRACTION actuator (skid control ECU), the skid control ECU sets a DTC and the operation is prohibited by the fail-safe function. This DTC is set when the voltage supplied to terminal +BS is outside the DTC detection threshold, due to abnormalities of the battery, power source circuits or charging circuits such as the alternator circuit.
The fail-safe function is canceled when the voltage to terminal IG1 returns to normal.
DTC No.
DTC Detecting Conditions
Trouble Areas
C1241/41
When any of following conditions detected:
  1. +BS terminal voltage 18 V or more, even momentarily.
  2. At vehicle speed 20 km/h (12 mph) or more, +BS terminal voltage 9.7 V or less for 0.021 seconds or more.
  3. At vehicle speed 20 km/h (12 mph) or more, +BS terminal voltage 7.5 V or less, even momentarily.
  1. Battery
  2. Charging system
  3. Power source circuit
  4. ABS and TRACTION actuator (skid control ECU)

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. INSPECT BATTERY
  1. Check the battery voltage.

    Standard Voltage:
    11 to 14 V



NG
CHECK CHARGING SYSTEM
OK


2. INSPECT FUSES (ABS2/VSC2)

  1. C117851E04
    Remove the ABS2/VSC2 fuse from the engine room R/B.

  1. Measure the resistance.

    Standard Resistance:
    Below 1 Ω



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (BATTERY - SKID CONTROL ECU - BODY GROUND)

  1. C129347E04
    Disconnect the skid control ECU connector.

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Specified Condition
    A39-14 (+BS) - Body ground
    10 to 14 V

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    A39-13 (GND1) - Body ground
    Below 1 Ω
    A39-26 (GND2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Drive the vehicle at 20 km/h (12 mph) or more for several seconds.

  1. Check if the same DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C1231/31 Steering Angle Sensor Circuit Malfunction (from Nov 2005)C1246/46 Master Cylinder Pressure Sensor Malfunction (+ C1281/81) (from Nov 2005) →