REMOVAL
Removal / installation · Vehicles built from Aug 2005
| 1. DRAIN BRAKE FLUID |
- NOTICE:
- Immediately wash off any brake fluid that comes into contact with any painted surfaces.
| 2. REMOVE BATTERY |
| 3. REMOVE BATTERY TRAY |
| 4. REMOVE BATTERY CARRIER |
| 5. DISCONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle) |
![]() ![]() |
Slide the clip and disconnect the reservoir tube.
| 6. REMOVE BRAKE MASTER CYLINDER |
- NOTICE:
- Remove the brake master cylinder after depressing the brake pedal several times and bleeding the vacuum pressure from inside the brake booster.
Disconnect the brake fluid level warning switch connector.
w/o ABS:

Using SST, separate the 3 brake tubes from the brake tube way.
- SST
- 09023-00100
Using SST, separate the 2 brake tubes from the brake master cylinder.

- SST
- 09023-00100
w/ ABS:

Remove the 2 nuts and remove the brake master cylinder.
w/o ABS:

Remove the 2 nuts and brake tube way and remove the brake master cylinder.
Remove the O-ring from the brake master cylinder.

