2005-2008 Yaris · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

C116942
  1. Fix the brake master cylinder in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a pin punch and hammer, tap out the straight pin.

  1. Remove the master cylinder reservoir and 2 grommets.

  1. Remove the filler cap and strainer from the master cylinder reservoir.


2. REMOVE BRAKE MASTER CYLINDER KIT

C121686
  1. Push in the piston and remove the snap ring using snap ring pliers.

  1. C121687
    w/o VSC:

    1. Push in the piston and remove the piston stopper bolt and gasket.

  1. C121688
    w/ VSC:

    1. Push in the piston and remove the straight pin by turning over the cylinder body.

      NOTICE:
      Use a piece of cloth to prevent damage.

  1. Remove the No. 1 piston from the master cylinder body by pulling it straight out.

    NOTICE:
    Do not scratch the inside of the cylinder body.

  1. C053481
    Tap the flanged part against wooden blocks until the end of the No. 2 piston comes out. When the end of the No. 2 piston comes out, pull the No. 2 piston straight out of the master cylinder body.

    NOTICE:
    Do not scratch the inside of the cylinder body.

← REMOVAL (from Aug 2005)INSPECTION (from Aug 2005) →