2005-2008 Yaris · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jan 2006


1. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.


2. REMOVE BATTERY

3. REMOVE BATTERY TRAY

4. REMOVE BATTERY CARRIER

5. DISCONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle)

C116933
  1. Slide the clip and disconnect the reservoir tube.


6. REMOVE BRAKE MASTER CYLINDER

NOTICE:
Remove the brake master cylinder after depressing the brake pedal several times and bleeding the vacuum pressure from inside the brake booster.

  1. Disconnect the brake fluid level warning switch connector.

  1. w/o ABS:

    1. C121832E01
      Using SST, separate the 3 brake tubes from the brake tube way.
      SST
      09023-00100  

  1. C121690E01
    Using SST, separate the 2 brake tubes from the brake master cylinder.
    SST
    09023-00100  

  1. C116934
    w/ ABS:

    1. Remove the 2 nuts and remove the brake master cylinder.

  1. C121833
    w/o ABS:

    1. Remove the 2 nuts and brake tube way and remove the brake master cylinder.

  1. Remove the O-ring from the brake master cylinder.

← COMPONENTS (from Jan 2006)DISASSEMBLY (from Jan 2006) →