DISASSEMBLY
Removal / installation · Vehicles built from Jan 2006
| 1. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY |
![]() ![]() |
Fix the brake master cylinder in a vise between aluminum plates.
- NOTICE:
- Do not overtighten the vise.
Using a pin punch and hammer, tap out the straight pin.
Remove the master cylinder reservoir and 2 grommets.
Remove the filler cap and strainer from the master cylinder reservoir.
| 2. REMOVE BRAKE MASTER CYLINDER KIT |
![]() ![]() |
Push in the piston and remove the snap ring using snap ring pliers.
Push in the piston and remove the piston stopper bolt and gasket.

Remove No. 1 piston from the master cylinder body by pulling it straight out.
- NOTICE:
- Do not scratch the inside of the cylinder body.
Tap the flanged part against wooden blocks until the end of No. 2 piston comes out. When the end of No. 2 piston comes out, pull No. 2 piston straight out of the master cylinder body.

- NOTICE:
- Do not scratch the inside of the cylinder body.


