2005-2008 Yaris · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jan 2006


1. INSTALL BRAKE MASTER CYLINDER KIT
  1. Fix the master cylinder body in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. C121834E01
    Apply lithium soap base glycol grease to the rubber part as shown in the illustration.

  1. Install No. 1 piston and No. 2 piston onto the master cylinder body.

    NOTICE:
    1. Install the piston straight while being not to careful damage the inside of the cylinder.
    2. Do not damage the lip of the cylinder cup.

  1. C121687
    Push in the piston and install a new gasket and a new piston stopper bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. C121686
    Install the snap ring using snap ring pliers with the piston pushed in.

    NOTICE:
    Do not scratch the inside of the cylinder body.


2. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Install the strainer and filler cap onto the master cylinder reservoir.

  1. Apply lithium soap base glycol grease to the 2 grommets and install them onto the master cylinder body.

  1. Install the master cylinder reservoir onto the master cylinder body.

  1. C116942
    Using a pin punch and hammer, tap in the straight pin.

← INSPECTION (from Jan 2006)INSTALLATION (from Jan 2006) →