2005-2008 Yaris · Service Manual SECURITIES

B1269 Theft Deterrent ECU Communication Stop

Diagnostic trouble codes · Vehicles built from Nov 2006

DESCRIPTION

DTC B1269 is output when the communication between the theft warning ECU (theft deterrent ECU) and the certification ECU assembly stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B1269
No communication from certification ECU assembly for more than 3.5 seconds.
  1. Theft warning ECU assembly
  2. Wire harness and connector

WIRING DIAGRAM

B165761E01

INSPECTION PROCEDURE


1. CHECK THEFT WARNING ECU ASSEMBLY
B121327E14
  1. Disconnect the D86 theft warning ECU connector.

  1. Check the voltage between the wire harness side connector and body ground.

    Standard voltage:
    Tester Connection
    Specified Condition
    D86-11 (+B1) - Body ground
    11 to 14 V
    D86-13 (+B2) - Body ground
    11 to 14 V

  1. Reconnect the theft warning ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - CERTIFICATION ECU)

  1. B165762E01
    Disconnect the D86 theft warning ECU connector.

  1. Disconnect the D60 certification ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    D86-24 (BRK+) - D60-24 (SECI)
    Below 1 Ω
    D86-25 (BRK-) - D60-25 (SECO)
    Below 1 Ω
    D86-24 (BRK+) or D60-24 (SECI) - Body ground
    10 kΩ or higher
    D86-25 (BRK-) or D60-25 (SECO) - Body ground
    10 kΩ or higher
    D86-16 (E) - Body ground
    Below 1 Ω

  1. Reconnect the theft warning ECU connector.

  1. Reconnect the certification ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU)

  1. B167179E02
    Disconnect the D66 main body ECU connector.

  1. Disconnect the D60 certification ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    D66-15 (CANH) - D60-27 (CANH)
    Below 1 Ω
    D66-16 (CANL) - D60-28 (CANL)
    Below 1 Ω
    D66-15 (CANH) or D60-27 (CANH) - Body ground
    10 kΩ or higher
    D66-16 (CANL) or D60-28 (CANL) - Body ground
    10 kΩ or higher

  1. Reconnect the main body ECU connector.

  1. Reconnect the certification ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY


← DIAGNOSTIC TROUBLE CODE CHART (from Nov 2006)Engine Hood Courtesy Switch Circuit (from Nov 2006) →