2005-2008 Yaris · Service Manual SECURITIES

Engine Hood Courtesy Switch Circuit

Circuit diagnosis · Vehicles built from Nov 2006

DESCRIPTION

The engine hood courtesy switch is built into the engine hood lock assembly. The switch turns on when the engine hood is opened and turns off when the engine hood is closed.

WIRING DIAGRAM

B121328E08

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (ENGINE HOOD COURTESY SWITCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the intelligent tester main switch ON.

  1. Select the item below in the DATA LIST and read the display on the tester.

    Theft Warning ECU:
    Item
    Measurement Item/Display (Range)
    Normal Condition
    Diagnostic Note
    Hood Curtesy Switch
    Engine hood courtesy switch signal/ON or OFF
    ON: Engine hood is OPEN
    OFF: Engine hood is CLOSED
    -



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)

  1. E107106E01
    Disconnect the A56 engine hood courtesy switch connector.

  1. Check the resistance of the engine hood courtesy switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Lock
    (OFF)
    10 kΩ or higher
    1 - 2
    Unlock
    (ON)
    Below 1 Ω

  1. Reconnect the courtesy switch connector.



NG
REPLACE HOOD LOCK ASSEMBLY
OK


3. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - ENGINE HOOD COURTESY SWITCH)

  1. B121330E03
    Disconnect the D86 theft warning ECU and A56 engine hood courtesy switch connectors.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    D86-4 (DSWH) - A56-2
    Below 1 Ω
    D86-4 (DSWH) - Body ground
    10 kΩ or higher

  1. Reconnect the theft warning ECU and engine hood courtesy switch connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND)
  1. Disconnect the A56 engine hood courtesy switch connector.

  1. B121331E03
    Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A56-1 - Body ground
    Below 1 Ω

  1. Reconnect the engine hood courtesy switch connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY


← B1269 Theft Deterrent ECU Communication Stop (from Nov 2006)Horn Circuit (from Nov 2006) →