2005-2008 Yaris · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Aug 2005


CHECK RADIO RECEIVER (with MP3 / WMA PLAYER)
C138638E01
  1. Disconnect the D10 receiver connector.

  2. Measure the resistance and voltage of the wire harness side connector.

    Standard: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND (D10-7)
    - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    ACC (D10-3)
    - GND (D10-7)
    GR - W-B
    ACC power supply
    Ignition switch on (ACC)
    10 to 14 V
    B (D10-4)
    - GND (D10-7)
    L - W-B
    Battery power supply
    Always
    10 to 14 V

    HINT:
    If the results are not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the D10 receiver connector.

  4. Measure the voltage of the connector.

    Standard Voltage: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    FR+ (D10-1)
    - GND (D10-7)
    GR - W-B
    Sound signals (front right)
    Audio system operating
    Waveform synchronized with sound output
    FL+ (D10-2)
    - GND (D10-7)
    P - W-B
    Sound signals (front left)
    Audio system operating
    Waveform synchronized with sound output
    FR- (D10-5)
    - GND (D10-7)
    Y - W-B
    Sound signals (front right)
    Audio system operating
    Waveform synchronized with sound output
    FL- (D10-6)
    - GND (D10-7)
    V - W-B
    Sound signals (front left)
    Audio system operating
    Waveform synchronized with sound output
    RR+ (D11-1)
    - GND (D10-7)
    R - W-B
    Sound signals (rear right)
    Audio system operating
    Waveform synchronized with sound output
    RL+ (D11-2)
    - GND (D10-7)
    B - W-B
    Sound signals (rear left)
    Audio system operating
    Waveform synchronized with sound output
    RR- (D11-3)
    - GND (D10-7)
    W - W-B
    Sound signals (rear right)
    Audio system operating
    Waveform synchronized with sound output
    RL- (D11-6)
    - GND (D10-7)
    Y - W-B
    Sound signals (rear left)
    Audio system operating
    Waveform synchronized with sound output
    ANT (D10-8)
    - GND (D10-7)
    B - W-B
    Power source of antenna
    Radio switch ON (AM or FM)
    10 to 14 V
    SPD (D53-3) *1
    - GND (D10-7)
    W - W-B
    Vehicle speed signal
    Turn ignition switch on (IG), drive wheels turned slowly
    Pulse generation
    SW1 (D53-7)
    - SWG (D53-6)
    P - G
    Steering pad switch signal
    No steering pad switches pushed
    4 V or higher
    SW1 (D53-7)
    - SWG (D53-6)
    P - G
    Steering pad switch signal
    Steering pad SEEK+ switch pushed
    Approx. 0.1 V
    SW1 (D53-7)
    - SWG (D53-6)
    P - G
    Steering pad switch signal
    Steering pad SEEK- switch pushed
    Approx. 0.9 V
    SW1 (D53-7)
    - SWG (D53-6)
    P - G
    Steering pad switch signal
    Steering pad VOL+ switch pushed
    Approx. 1.5 V
    SW1 (D53-7)
    - SWG (D53-6)
    P - G
    Steering pad switch signal
    Steering pad VOL- switch pushed
    Approx. 3 V
    SW2 (D53-8)
    - SWG (D53-6)
    O - G
    Steering pad switch signal
    No steering pad switches pushed
    4 V or higher
    SW2 (D53-8)
    - SWG (D53-6)
    O - G
    Steering pad switch signal
    Steering pad MODE switch pushed
    Below 1 V
    *1: only for SEDAN

    HINT:
    If the results are not as specified, there may be a malfunction in the wire harness.


CHECK RADIO RECEIVER (without MP3 / WMA PLAYER)
I100979E03
  1. Disconnect the D10 receiver connector.

  2. Measure the resistance and voltage of the wire harness side connector.

    Standard: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND (D10-7)
    - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    ACC (D10-3)
    - GND (D10-7)
    GR - W-B
    ACC power supply
    Ignition switch on (ACC)
    10 to 14 V
    B (D10-4)
    - GND (D10-7)
    L - W-B
    Battery power supply
    Always
    10 to 14 V

    HINT:
    If the results are not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the D10 receiver connector.

  4. Measure the voltage of the connector.

    Standard Voltage: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    FR+ (D10-1)
    - GND (D10-7)
    GR - W-B
    Sound signals (front right)
    Audio system operating
    Waveform synchronized with sound output
    FL+ (D10-2)
    - GND (D10-7)
    P - W-B
    Sound signals (front left)
    Audio system operating
    Waveform synchronized with sound output
    FR- (D10-5)
    - GND (D10-7)
    Y - W-B
    Sound signals (front right)
    Audio system operating
    Waveform synchronized with sound output
    FL- (D10-6)
    - GND (D10-7)
    V - W-B
    Sound signals (front left)
    Audio system operating
    Waveform synchronized with sound output
    RR+ (D11-1)
    - GND (D10-7)
    R - W-B
    Sound signals (rear right)
    Audio system operating
    Waveform synchronized with sound output
    RL+ (D11-2)
    - GND (D10-7)
    B - W-B
    Sound signals (rear left)
    Audio system operating
    Waveform synchronized with sound output
    RR- (D11-3)
    - GND (D10-7)
    W - W-B
    Sound signals (rear right)
    Audio system operating
    Waveform synchronized with sound output
    RL- (D11-6)
    - GND (D10-7)
    Y - W-B
    Sound signals (rear left)
    Audio system operating
    Waveform synchronized with sound output
    ANT (D10-8)
    - GND (D10-7)
    B - W-B
    Power source of antenna
    Radio switch ON (AM or FM)
    10 to 14 V

    HINT:
    If the results are not as specified, there may be a malfunction in the wire harness.

← PROBLEM SYMPTOMS TABLE (from Jan 2006)DTC CHECK / CLEAR (from Aug 2005) →