2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

Back-up Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

This is back-up power source circuit for the air conditioning amplifier. Power is supplied even when the ignition switch is turned off and is used for functions such as the diagnostic trouble code memory.

WIRING DIAGRAM

E118638E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-B)

  1. B122728E03
    Remove the ECU-B fuse from the engine room relay block.

  1. Measure the resistance.

    Standard resistance:
    Below 1 Ω

  1. Reinstall the ECU-B fuse.



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)
E118637E04
  1. Disconnect the E11 air conditioning amplifier connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E11-21 (B) - Body ground
    Always
    10 to 14 V

  1. Reconnect the air conditioning amplifier connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND)
E118637E03
  1. Disconnect the E11 air conditioning amplifier connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E11-14 (GND) - Body ground
    Below 1 Ω

  1. Reconnect the air conditioning amplifier connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER


← IG Power Source Circuit (from Aug 2005)PRECAUTION (from Aug 2005) →