IG Power Source Circuit
Circuit diagnosis · Vehicles built from Aug 2005
DESCRIPTION
This is the main power source supplied to the air conditioning amplifier when the ignition switch is on (IG). This power source is used for operating components, such as the air conditioning amplifier and servo motors.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (A/C) |
Remove the A/C fuse form the main body ECU.
Measure the resistance.
- Standard resistance:
- Below 1 Ω
Reinstall the A/C fuse.
|
|
||||
| OK | |
| 2. INSPECT AIR CONDITIONING AMPLIFIER |
![]() ![]() |
Disconnect the E11 air conditioning amplifier connector.
Measure the voltage.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E11-1 (IG+) - E11-14 (GND)
Ignition switch on (IG)
10 to 14 V
Reconnect the air conditioning amplifier connector.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - MAIN BODY ECU) |
![]() ![]() |
Disconnect the E11 air conditioning amplifier connector.
Disconnect the 4S main body ECU connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
E11-1 (IG+) - 4S-10
Below 1 Ω
Reconnect the air conditioning amplifier connector.
Reconnect the main body ECU connector.
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND) |
![]() ![]() |
Disconnect the E11 air conditioning amplifier connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
E11-14 (GND) - Body ground
Below 1 Ω
Reconnect the air conditioning amplifier connector.
|
|
||||
| OK | ||
| ||



