2005-2008 Yaris · Service Manual ENGINE

PRECAUTION

Precautions · Vehicles built from Nov 2005


1.IGNITION SWITCH EXPRESSIONS
  1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch (position)
    Engine Switch (condition)
    Ignition Switch off
    LOCK
    Off
    Ignition Switch on (IG)
    ON
    On (IG)
    Ignition Switch on (ACC)
    ACC
    On (ACC)
    Engine Start
    START
    Start


2.MAINTENANCE PRECAUTIONS
  1. Do not stop the engine immediately after pulling a trailer, or after high speed or uphill driving. Let the engine idle for 20 to 120 seconds before turning the ignition switch off. (The appropriate idling time varies according to the driving condition.)

  2. Avoid quick acceleration and increases in engine speed immediately after starting a cold engine.

  3. If the turbocharger is found to be defective, it must be replaced. Also, investigate the cause of the trouble including the conditions in which the turbocharger has been used. Repair or replace the following if necessary.

    1. Engine oil level and quality.

    2. Oil lines leading to turbocharger.

  4. A118859E01
    Pay due attention when removing and reinstalling the turbocharger assembly. Do not drop, grasp, or shock easily-deformed assembly parts, such as the actuator or push rod, when removing or reinstalling the assembly.

  5. Cover both the intake and exhaust ports and the oil inlet before remove them, to prevent dirt or foreign objects from being introduced.

  6. A098585E01
    If replacing the turbocharger, check for an accumulation of sludge particles in the oil pipe.

  7. Thoroughly remove any old gasket sticking to the lubrication oil pipe flange and turbocharger oil flange.

  8. If replacing the bolt(s) and nut(s), Toyota genuine parts must be used to prevent breakage or deformation.

  9. A098589E01
    If replacing the turbocharger, put 20cm3 (1.2 cu in.) of fresh oil into the turbocharger oil inlet hole, then turn the turbine wheel by hand to spread the oil to the bearing.

  10. If overhauling or replacing the engine, cut the fuel supply after reassembling, and crank the engine for 30 seconds to feed oil throughout the engine. Idle the engine for 60 seconds.

  11. A098587E01
    Since the turbine wheels run at an extremely high speed, running the engine without the air cleaner, case cover and hose damages the turbine wheel due to the introduction of foreign particles.

← INSTALLATION (from Nov 2006)PARTS LOCATION (from Nov 2005) →