2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT SPOILER COVER LH (w/ Front Spoiler)

  1. B119950
    Remove the 5 screws and the front spoiler cover.


3. REMOVE FRONT SPOILER COVER RH (w/ Front Spoiler)

  1. B119934
    Remove the 4 screws and the front spoiler cover.


4. REMOVE FRONT BUMPER COVER

  1. B114359E01
    Apply protective tape as shown in the illustration.

  1. B119953
    w/ Front Spoiler:

    1. Remove the 3 screws.

    2. Remove the 2 screw grommets.

    3. Remove the 7 clips.

  1. B114360
    w/o Front Spoiler:

    1. Remove the 8 screws.

    2. Remove the 2 screw grommets.

    3. Remove the 7 clips.

  1. B114361E01
    w/ Fog Light:

    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.

    2. Disconnect the 2 fog light connectors.

  1. B114365E01
    w/o Fog Light:

    1. Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.

  1. B119954
    w/ Front Spoiler:

    1. Remove the 2 clips and the 4 screw grommets.

  1. B114366
    w/o Front Spoiler:

    1. Remove the 2 clips and the screw grommet.


5. REMOVE ENGINE UNDER COVER
  1. Remove the 5 bolts, 4 screws and 2 clips and remove the engine under cover.


6. REMOVE AIR CLEANER ASSEMBLY

  1. A118837
    Disconnect the mass air flow meter connector.

  1. Disengage the 2 clamps, and separate the wire harness from the air cleaner cap.

  1. A118838
    Unfasten the 2 lock clamps, and separate the air cleaner cap.

  1. Loosen the hose clamp, and remove the air cleaner cap.

  1. A118839
    Remove the air cleaner element.

  1. A118840
    Remove the 3 bolts and air cleaner case.


7. DISCONNECT AIR HOSE NO. 3

  1. A126330
    Loosen the hose clamp, and disconnect air hose No. 3.


8. DISCONNECT AIR HOSE NO. 2

  1. A126331
    Loosen the hose clamp, and disconnect air hose No. 2.


9. SEPARATE HOOD LOCK ASSEMBLY

  1. A118843
    Remove the 3 bolts, and separate the hood lock.

  1. A118844
    Separate the hood lock control cable from the radiator support upper.


10. SEPARATE RADIATOR RESERVE TANK ASSEMBLY

  1. A118842
    Remove the bolt, and separate the radiator reserve tank.


11. REMOVE RADIATOR SUPPORT UPPER

  1. A118845
    Disconnect the horn connector.

  1. Disengage the clamp, and separate the wire harness.

  1. Remove the 4 bolts and radiator support upper.


12. REMOVE INTERCOOLER ASSEMBLY
  1. Disengage the 2 clamps, and separate the wire harness.

  1. A118846
    Disconnect the hose.

  1. A118847
    Remove the intercooler.

  1. Remove the radiator support cushion.

  1. Remove the 2 grommets.

← COMPONENTS (from Nov 2005)INSTALLATION (from Nov 2005) →