2005-2008 Yaris · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT VACUUM REGULATING VALVE

A126323E01

  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      11 to 13Ω 20°C (68°F)

      If the result is not as specified, replace the vacuum regulating valve.

    2. A126324E01
      Using an ohmmeter, measure the resistance between each terminal and the body.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - Body
      1MΩ or higher
      2 - Body
      1MΩ or higher

      If the result is not as specified, replace the vacuum regulating valve.

  1. A126325E01
    Check the air tightness.

    1. Apply a vacuum to the vacuum inlet port.

    2. Check that the needle of the vacuum pump indicates decrease of 66.7 kPa (500 mmHg, 19.7 in.Hg) or less.
      If the air tightness is not as specified, replace the vacuum regulating valve.

  1. A126326E01
    Check the operation.

    1. Apply 4 dry batteries of 1.5V in series.

    2. Check that the needle does not move when a vacuum is applied to the vacuum inlet port.
      If the operation is not as specified, replace the vacuum regulating valve.

← REMOVAL (from Nov 2005)INSTALLATION (from Nov 2005) →