2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2006


1. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY

A119162
  1. Install the spring.

  1. A119161
    Install the fuel sub-tank.

  1. A119160
    Install a new retainer ring.


2. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY

A119159
  1. Apply gasoline to 2 new O-rings.

  1. A119158
    Install the pressure regulator assembly.


3. INSTALL FUEL PUMP

A125203E01
  1. Apply gasoline to a new O-ring and install it onto the fuel filter.

    NOTICE:
    Do not disassemble the fuel pump or the suction filter because they are nonreusable parts.

  1. A119164
    Connect the fuel pump harness.

  1. A105596
    Engage the 5 claws on the fuel pump.

    NOTICE:
    1. Do not remove the suction filter.
    2. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.

  1. A119157
    Engage the 2 claws on the fuel suction support.

  1. A119168
    Engage the 2 claws on the fuel suction support and install the fuel filter and the fuel pump onto the fuel sub-tank.

  1. A109341
    Connect the fuel pump filter hose.

  1. A105592
    Connect the connector to the fuel pump harness.


4. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A119165
    Install the fuel sender gauge assembly by sliding it downward.

  1. A105590
    Connect the connector to the fuel sender gauge assembly.

← DISASSEMBLY (from Nov 2006)INSTALLATION (from Nov 2006) →