2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

  1. A125680
    Loosen the radiator drain cock plug.

  1. Remove the reserve tank cap and drain the coolant.

  1. Tighten the radiator drain cock plug.

    A128304E01


2. REMOVE HOOD TO COWL TOP SEAL

  1. E113851
    Disengage the 7 clips and remove the hood to cowl top seal.


3. REMOVE COWL TOP VENTILATOR LOUVER CENTER NO.1 (for LHD)

  1. A125670
    Disengage the 2 hooks and remove cowl top ventilator louver center No. 1.

  1. Disconnect the washer hose.


4. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for RHD)

  1. A125782
    Disengage the 2 hooks and remove cowl top ventilator louver center No. 2.


5. REMOVE BATTERY

6. REMOVE BATTERY TRAY

7. REMOVE WIRING HARNESS CLAMP BRACKET

  1. A125669
    Remove the bolt and clip and remove the wiring harness clamp bracket.


8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

  1. A125668E01
    Disconnect the engine coolant temperature sensor connector.

  1. Using SST, remove the engine coolant temperature sensor and gasket.

    SST
    09817-33190  

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →