2005-2008 Yaris · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE AIR CLEANER INLET NO.1 (for 2SZ-FE)

C127624
  1. Remove air cleaner inlet No. 1.


3. REMOVE BATTERY HOLD DOWN CLAMP

4. REMOVE BATTERY

5. REMOVE BATTERY TRAY

6. REMOVE BATTERY CARRIER (for 1KR-FE)

C106985
  1. Remove the 4 bolts and the battery carrier.


7. REMOVE BATTERY CARRIER (for 2SZ-FE)

C106370
  1. Remove the 5 bolts and the battery carrier.


8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

9. REMOVE REAR CONSOLE BOX COVER

B118991
  1. Disengage the 8 claws and remove the console box rear cover.


10. REMOVE REAR CONSOLE BOX ASSEMBLY

B118993
  1. Remove bolt <F>.

  1. Disengage the 2 clips and remove the console box rear.


11. SEPARATE OXYGEN SENSOR CONNECTOR

12. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 1KR-FE)
  1. Remove the 4 bolts and 4 compression springs.

  1. Remove exhaust pipe support No. 4 and the exhaust front pipe assembly.

    A115439

  1. Remove the 2 exhaust pipe gaskets.


13. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 2SZ-FE)

  1. Remove the 2 bolts and 2 compression springs.

    A127393

  1. Remove the 3 No. 4 exhaust pipe supports and remove the exhaust pipe assembly front.


14. REMOVE FRONT FLOOR HEAT INSULATOR NO.2

C127608
  1. Remove the 2 bolts and remove front floor heat insulator No. 2.


15. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

C125966
  1. Remove the 4 bolts and remove the floor shift shift lever.


16. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

  1. C136390
    Disconnect the control shift cable from the shift lever.

    HINT:
    Push the cable end at an angle and remove it.

  1. C125964
    Remove the clip and disconnect the control select cable from the shift lever.

  1. C125965
    Pinch the protrusion of the control cable and pull the cable upward.

  1. C116858
    Remove the 2 clips and disconnect the 2 cables from the transaxle.

  1. Remove the 2 clips and disconnect the 2 cables from the control cable bracket.

  1. C127609
    Remove the 3 nuts and remove the transmission control cable.

← COMPONENTS (from Nov 2005)INSTALLATION (from Nov 2005) →