INSTALLATION
Removal / installation · Vehicles built from Nov 2005
| 1.
INSTALL GLOW PLUG ASSEMBLY |
 |
Clean the glow plug installation holes in the cylinder head.
Using a 10 mm deep socket wrench , install the 4 glow plugs.
-
Torque:
- :
- 13 N*m{
127 kgf*cm
, 9 ft.*lbf
}
| 2.
INSTALL GLOW PLUG NO.1 CONNECTOR |
 |
Install glow plug connector No. 1 with the 4 nuts.
-
Torque:
- 1.6 N*m{
15 kgf*cm
, 14 in.*lbf
}
Connect the glow terminal with the nut.
-
Torque:
- 3.8 N*m{
40 kgf*cm
, 34 in.*lbf
}
- NOTICE:
- Install the glow terminal in the correct direction.
- Install the 5 screw grommets.
- NOTICE:
- Push the screw grommet into the threaded portion of the glow plug by hand, and then turn it clockwise.
| 3.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 5.4 N*m{
55 kgf*cm
, 48 in.*lbf
}
| 4.
INSTALL ENGINE COVER SUB-ASSEMBLY NO. 1
|
 |
Engage the 4 pins and install engine cover No. 1.