B1242 Wireless Door Lock Tuner Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
This door control receiver receives signals from the transmitter and sends these signals to the main body ECU.| DTC No. |
DTC Detection Condition |
Suspected Area |
| B1242 |
In diagnostic mode, applicable RDA signal cannot be received within 1 second of PRG signal being output from main body ECU. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - DOOR CONTROL RECEIVER) |
Disconnect the D33 main body ECU connector.

Disconnect the J13 door control receiver connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
D33-16 (RDA) - J13-2 (RDA)
Below 1 Ω
D33-16 (RDA) or J13-2 (RDA) - Body ground
10 kΩ or higher
D33-17 (PRG) - J13-3 (PRG)
Below 1 Ω
D33-17 (PRG) or J13-3 (PRG) - Body ground
10 kΩ or higher
Reconnect the main body ECU connector.
Reconnect the door control receiver connector.
|
|
||||
| OK | |
| 2. INSPECT DOOR CONTROL RECEIVER (+B TERMINAL) |
Disconnect the J13 door control receiver connector.
Measure the voltage.

- Standard voltage:
Tester Connection
Condition
Specified Condition
J13-5 (+B) - Body ground
Always
10 to 14 V
Reconnect the door control receiver connector.
|
|
||||
| OK | |
| 3. INSPECT DOOR CONTROL RECEIVER (GND TERMINAL) |
Disconnect the J13 door control receiver connector.
Measure the resistance.

- Standard resistance:
Tester Connection
Specified Condition
J13-1 (GND) - Body ground
Below 1 Ω
Reconnect the door control receiver connector.
|
|
||||
| OK | |
| 4. REPLACE DOOR CONTROL RECEIVER |
Replace the door control receiver.
Perform the REGISTRATION procedures.
- HINT:
- If a new or normal functioning door control receiver is available, connect it and check if the wireless door lock function is normal or the DTC is output. If the alternative receiver functions normally, replace the original door control receiver.
| NEXT | |
| 5. RECHECK DTC |
Clear the DTC.
Check if the same DTC is detected.
- HINT:
- Reinstall the parts, such as sensors and connectors, and restore the vehicle to its previous conditions before rechecking for DTCs.
Result: Condition
Proceed to
DTC (B1242) is output
A
DTC (B1242) is not output (When troubleshooting in accordance with DTC CHART)
B
DTC (B1242) is not output (When troubleshooting in accordance with PROBLEM SYMPTOMS TABLE)
C
|
|
||||
|
|
||||
| A | ||
| ||
