2005-2008 Yaris · Service Manual TRANSMISSION

Pattern Select Switch Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

While the vehicle is driven with the shift lever is in the E position, the most appropriate gear is automatically selected according to the accelerator pedal opening angle and vehicle speed. In this time, shift control can be switched between normal mode (E) and sports mode (Es) by pressing the pattern select switch.

WIRING DIAGRAM

C126859E01

INSPECTION PROCEDURE


1. INSPECT PATTERN SELECT SWITCH ASSEMBLY
C127421
  1. Remove the pattern select switch.

  1. Check the resistance of the pattern select switch terminals.

    Standard resistance:
    Tester Connections
    Switch Conditions
    Specified Conditions
    1 - 4
    ON
    Below 1 Ω
    1 - 4
    OFF
    10 kΩ or higher

  1. Reinstall the pattern select switch.



NG
REPLACE PATTERN SELECT SWITCH ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU - BODY GROUND)
C112718E06
  1. Disconnect the transmission control ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Switch Conditions
    Specified Conditions
    PWR (D79-23) - Body ground
    OFF
    10 kΩ or higher
    PWR (D79-23) - Body ground
    ON
    Below 1 Ω

  1. Reconnect the transmission control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT TRANSMISSION CONTROL ECU ASSEMBLY (PWR TERMINAL VOLTAGE)
C112714E25
  1. Turn the ignition switch on (IG).

  1. Measure the voltage between the terminal of the transmission control ECU connector and the body ground when the pattern select switch is ON and OFF.

    Standard voltage:
    Tester Connections
    Switch Conditions
    Specified Conditions
    PWR (D79-23) - Body ground
    Pattern select switch OFF
    10 to 14 V
    PWR (D79-23) - Body ground
    Pattern select switch ON
    Below 1 V



NG
REPLACE TRANSMISSION CONTROL ECU ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Starter Signal Circuit (from Nov 2005)IG Signal Circuit (from Nov 2005) →