2005-2008 Yaris · Service Manual TRANSMISSION

Starter Signal Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

In this vehicle, the ST relay that supplies power to the starter motor is operated by the cranking holding function of the ECM. When the appropriate vehicle conditions are satisfied, the brake pedal is depressed and the transmission gear is in neutral, the engine can be cranked. If the brake pedal is not depressed or the transmission gear is not in neutral, the engine cannot be cranked.
During cranking, the ST relay operation signal (STA signal) is input into the STA terminal of the transmission control ECU, and is used to control the multi-mode manual transmission system.

WIRING DIAGRAM

C127412E01
C127413E02

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Powertrain / Multi-Mode M/T / Data List / STA Switch Signal.

  1. Check the value displayed on the tester when the ignition switch is turned on (IG) and the engine starts.

    Items
    [Abbreviation]
    Measurement Items: Display
    Normal Conditions
    Diagnostic Notes
    STA Switch Signal
    [STA SW Sig]
    STA signal:
    ON or OFF
    ON: During cranking
    -

    OK:
    [ON] displays in the STA Switch Signal during cranking.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU - ECM)

  1. C121797E03
    Disconnect the transmission control ECU connector.

  1. Disconnect the ECM connector.

  1. Remove the ST relay from the engine room relay block.

  1. Check the resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    STA (A49-9) - STA (A38-6)
    Below 1 Ω
    STA (A38-6) - Body ground
    10 kΩ or higher

  1. Reconnect the transmission control ECU connector.

  1. Reconnect the ECM connector.

  1. Reinstall the ST relay.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO STARTER SIGNAL CIRCUIT (ENGINE CONTROL SYSTEM)


← U0100 Lost Communication with ECM / PCM "A" (from Nov 2005)Pattern Select Switch Circuit (from Nov 2005) →