Wireless Door Lock Buzzer Does not Sound
Circuit diagnosis · Vehicles built from Aug 2005
SYSTEM DESCRIPTION
Each of the entry and start system warnings use the wireless door lock buzzer to alert the driver. The certification ECU determines whether the wireless door lock buzzer must sound in accordance with the warning conditions.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST BY INTELLIGENT TESTER (WIRELESS DOOR LOCK BUZZER) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the wireless door lock buzzer sounds.
- Certification ECU Assembly:
Item
Test Details
Diagnostic Note
Buzzer Resp Sound
Wireless door lock buzzer
ON / OFF
-
- OK:
- Wireless door lock buzzer sounds.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - WIRELESS DOOR LOCK BUZZER - BODY GROUND) |
Disconnect the A30 buzzer connector.

Disconnect the D60 ECU connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
BZR (D60-21) - A30-1
Below 1 Ω
BZR (D60-21) - Body ground
10 kΩ or higher
A30-1 - Body ground
10 kΩ or higher
A30-2 - Body ground
Below 1 Ω
Reconnect the ECU connector.
Reconnect the buzzer connector.
|
|
||||
| OK | |
| 3. INSPECT WIRELESS DOOR LOCK BUZZER |
Remove the wireless door lock buzzer.

Measure the resistance.
- HINT:
- The buzzer circuit is built into the ECU, not into the buzzer itself. When the battery voltage is applied directly to the buzzer, the buzzer will not sound.
- Standard resistance:
Tester Connection
Specified Condition
A30-1 - A30-2
Approx. 1 kΩ
Reinstall the buzzer.
|
|
||||
| OK | ||
| ||
