2005-2008 Yaris · Service Manual BRAKE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Nov 2005

HINT:
The intelligent tester can be used in steps 3, 5 and 6.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.DTCS AND FREEZE FRAME DATA CHECK AND CLEARANCE
        NEXT

        4.PROBLEM SYMPTOM CONFIRMATION

          Result:
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B


        B.
        A

        5.CAN COMMUNICATION SYSTEM CHECK
        1. Check for the output DTC relating to the CAN communication system.

          HINT:
          The ECU of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.


          Result:
          Result
          Proceed to
          CAN communication system DTC not output
          A
          CAN communication system DTC output
          B


        B.
        A

        6.DTC CHECK

          HINT:
          Click here.


          Result:
          Result
          Proceed to
          DTC output
          A
          DTC not output
          B


        B.
        A

        7.DTC CHART

          HINT:
          Click here.

        NEXT

        8.CIRCUIT INSPECTION

          HINT:
          When 2 or more DTCs are detected, perform circuit inspections one by one until the problem is identified.

        NEXT

        9.PROBLEM IDENTIFICATION
          NEXT

          10.REPAIR OR REPLACEMENT
            NEXT

            11.CONFIRMATION TEST
              NEXT

              ← SYSTEM DESCRIPTION (from Nov 2005)CALIBRATION (from Nov 2005) →