2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.

  1. A117319
    Install a vinyl hose onto the radiator.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly.

  1. Loosen the water drain plug, then drain the coolant.

    A128298E01


3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A127144
    Remove the grommet and 2 clamps and remove the air cleaner cap sub-assembly.


4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

5. SEPARATE NO. 1 RADIATOR HOSE

  1. A127182
    Separate the No. 1 radiator hose.


6. REMOVE E.F.I. ENGINE COOLANT TEMPERATURE SENSOR

  1. A127183
    Remove the engine coolant temperature sensor connector.

  1. A127184
    Using a 19 mm deep socket wrench, remove the engine coolant temperature sensor and gasket.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →