2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

  1. A127209
    Apply a light coat of gasoline to a new O-ring and install it onto the fuel pressure pulsation damper.

  1. A127208
    Install the fuel pressure pulsation damper with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. A127655
    Insert the fuel tube connector into the fuel delivery pipe until a click sound can be heard.

    NOTICE:
    1. Check that there are no scratches or foreign matter around the disconnected parts of the fuel tube connector and pipe before performing this work.
    2. After connecting the fuel tube, check that the fuel tube connector and pipe are securely connected by pulling them.

  1. A127194
    Install the fuel pipe clamp.


2. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

  1. A127144
    Install the air cleaner cap with the grommet and 2 clamps.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


5. CHECK FOR FUEL LEAKAGE

  1. A127178E01
    When using the intelligent tester.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and the intelligent tester main switch ON.

      NOTICE:
      Do not start the engine.

    3. Select the Active Test mode on the intelligent tester.

      HINT:
      Refer to the intelligent tester operator's manual for further details.

  1. Check that there is no fuel leakage anywhere in the fuel system after doing maintenance.

← REMOVAL (from Nov 2005)COMPONENTS (from Nov 2005) →