2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A127144
    Remove the grommet and 2 clamps and remove the air cleaner cap sub-assembly.


4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

5. REMOVE FUEL PRESSURE PULSATION DAMPER

  1. A127194
    Remove the fuel pipe clamp.

  1. A127202E01
    Pinch the retainer of the fuel tube connector, then pull out the fuel tube connector to disconnect the fuel tube from the fuel delivery pipe sub-assembly.

    NOTICE:
    1. Remove any dirt and foreign matter from the fuel tube connector before performing this work.
    2. Do not allow any scratches or foreign matter on the parts when disconnecting as the fuel tube connector has the O-ring that seals the pipe.
    3. Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Protect the disconnected parts by covering them with vinyl bags after disconnecting the fuel tube.
    6. If the fuel tube connector and pipe are stuck, push and pull to release them.

  1. A127208
    Remove the 2 bolts and remove the fuel pressure pulsation damper.

  1. A127209
    Remove the O-ring from the fuel pressure pulsation damper.

← COMPONENTS (from Nov 2005)INSTALLATION (from Nov 2005) →