INSTALLATION
Removal / installation · Vehicles built from Nov 2005
| 1. INSTALL STARTER ASSEMBLY (for C551A) |
Install the starter assembly with the 2 bolts.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Connect the connector.
Connect terminal 30 with the nut.
- Torque:
- 9.8 N*m{ 100 kgf*cm , 87 in.*lbf }
Close the terminal cap.
Install the harness clamp.
| 2. INSTALL STARTER ASSEMBLY (for C551) |
Install the starter assembly with the 2 bolts.

- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
Connect the connector.
Connect terminal 30 with the nut.
- Torque:
- 9.8 N*m{ 100 kgf*cm , 87 in.*lbf }
Close the terminal cap.
Install the harness clamp.
Install the wire harness bracket with the bolt.

- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Install the harness clamp.

| 3. INSTALL FLYWHEEL HOUSING SIDE COVER |
Insert the protruding portion into the end of the cylinder block and while pushing it along the cylinder block, fit the claw into the cylinder block.

- NOTICE:
- Make sure that the claw marks a click sound, indicating that it fits tightly.
- Replace the claw with a new one if it does not fit tightly or is deformed.
- Make sure that the claw marks a click sound, indicating that it fits tightly.
| 4. INSTALL BATTERY TRAY (for C551) |
| 5. INSTALL BATTERY (for C551) |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for C551A) |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
