2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL STARTER CLUTCH SUB-ASSEMBLY

  1. A127323E01
    Apply grease to the spline of the starter clutch sub-assembly and the starter armature assembly.

  1. A127324E01
    Place the starter clutch and inside pinion stop collar on the armature.

  1. Apply grease to a new snap ring, and install it onto the armature shaft.

  1. A127325E01
    Using a vise, compress the snap ring.

  1. A033587E01
    Hold the starter clutch, tap the armature shaft and install the pinion stop collar onto the snap ring with a plastic-faced hammer.


2. INSTALL STARTER ARMATURE ASSEMBLY

  1. A127309E01
    Install the starter armature onto the starter yoke assembly.


3. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. A104844E01
    Hold the starter yoke assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. While compressing the spring, install the starter brush holder onto the starter armature.

    NOTICE:
    Align the cutout of the starter yoke and the rubber and install the starter brush holder.

  1. A127308E01
    Install the starter commutator end frame onto the starter yoke.

  1. Install the washer onto the starter commutator end frame.

  1. A127307E01
    Install the slotted washer.

  1. A127306
    Install the starter commutator end frame cover onto the starter commutator end frame with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY

  1. A127326E01
    Align the groove of the starter yoke and the starter drive housing cover and install the starter yoke onto the starter drive housing.

  1. A127327E01
    Align the cutout of the starter drive housing with the protrusion of the starter yoke assembly.

  1. A127305
    Install the 2 bolts.

    Torque:
    4.8 N*m{ 48 kgf*cm , 42 in.*lbf }


5. INSTALL MAGNET STARTER SWITCH ASSEMBLY

  1. A127304E02
    Install the plunger onto the pinion drive lever.

  1. A127303
    Install the return spring onto the magnet starter switch.

  1. Using a torx socket wrench (T25), install the magnet starter switch with the 3 screws.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. A127302
    Connect the lead wire to the terminal with the washer and the nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

← INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →