2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A127328
    Remove the nut, then disconnect the lead wire from the magnet starter switch assembly.

  1. A127329
    Remove the 3 nuts from the starter drive housing assembly while holding the magnet starter switch assembly.

  1. Remove the magnet starter switch assembly.

  1. Remove the return spring.

  1. A127330E01
    Pull up the housing side of the plunger, then remove the plunger.


2. REMOVE STARTER YOKE ASSEMBLY

  1. A127331
    Using a torx drive T25, remove the 2 through bolts.

  1. A127332
    Pull out the starter yoke together with the starter commutator end frame assembly.

  1. A127333E01
    Pull the starter yoke out of the starter commutator end frame assembly.


3. REMOVE STARTER ARMATURE ASSEMBLY

  1. A095696E01
    Remove the starter armature assembly from the starter yoke assembly.


4. REMOVE STARTER ARMATURE PLATE

  1. Remove the armature plate from the starter drive housing assembly or the starter yoke assembly.

    A127334E01


5. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A127335
    Remove the 2 screws from the starter commutator end frame assembly.

  1. A095698
    Remove the claw of the clamp, then remove the brush holder assembly from the starter commutator end frame assembly.


6. REMOVE PLANET GEAR

  1. A095699
    Remove the 3 planet gears from the starter center bearing clutch sub-assembly.


7. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

  1. A127338E01
    Remove the starter center bearing clutch sub-assembly with starter pinion drive lever from the starter drive housing assembly.

  1. Remove the starter center bearing clutch sub-assembly and rubber seal from the starter pinion drive lever.

← REMOVAL (from Nov 2005)INSPECTION (from Nov 2005) →