2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

  1. A127338E02
    Apply grease to the starter pinion drive lever which is in contact with the starter pivot part of the starter pinion drive lever.

  1. Install the starter pinion drive lever and rubber seal into the starter center bearing clutch sub-assembly.

  1. Install the starter center bearing clutch together with the starter pinion drive lever into the starter drive housing assembly.


2. INSTALL PLANET GEAR

  1. A127339E01
    Apply grease to the planet gears and pin parts of the planetary shaft.

  1. Install the 3 planet gears.


3. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. A082651
    Install the brush holder.

  1. Using a screwdriver, hold the brush spring back, and install the 4 brushes into the brush holder.


4. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY

  1. A127340E01
    Fit the clamp of the brush holder into the starter commutator end frame assembly.

  1. A127341
    Install the commutator end frame with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }


5. INSTALL STARTER ARMATURE ASSEMBLY
  1. Align the rubber with the convex cutout of the starter yoke assembly.

  1. Install the starter armature assembly with the brush holder onto the starter yoke assembly.

    HINT:
    Support the starter armature so that it is not be pulled out from the starter brush holder by the magnetic force of the starter yoke assembly.


    A127342E01


6. INSTALL STARTER ARMATURE PLATE
  1. Install the starter armature plate onto the starter yoke assembly.

  1. Align the keyway of the starter plate with the key inside the starter yoke, then install the starter plate.

    A127343E01


7. INSTALL STARTER YOKE ASSEMBLY

  1. A127344E01
    Align the key of the starter yoke with the keyway located on the starter drive housing assembly.

  1. A127331
    Using a torx driver T25, install the starter yoke assembly using the 2 through bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


8. INSTALL MAGNET STARTER SWITCH ASSEMBLY

  1. A127345E01
    Apply grease to the hook.

  1. Connect the plunger hook to the starter pinion drive lever.

  1. A127346
    Install the return spring onto the magnet starter switch assembly.

  1. A127329
    Install the magnet starter switch assembly with the 3 nuts.

    Torque:
    2.3 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. A127328
    Connect the lead wire to the starter magnetic switch, then fasten it with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →