INSTALLATION
Removal / installation · Vehicles built from Nov 2005
| 1.
INSTALL EXHAUST PIPE ASSEMBLY FRONT |
 |
- Using vernier calipers, measure the free length of the compression spring.
- Minimum length:
- 40.5 mm (1.594 in.)
If the length is not as specified, replace the compression spring.
- Using a plastic hammer and a wooden block, tap in a new exhaust pipe gasket until its surface is flush with the exhaust manifold.
- NOTICE:
- Install the exhaust pipe gasket in the correct direction.
- Do not damage the outer surface of the exhaust pipe gasket.
- Do not reuse the exhaust pipe gasket.
- Do not push in the gasket with the exhaust pipe when connecting it.
Install the 3 No. 4 exhaust pipe supports.


Install the exhaust pipe assembly front with the 2 compression springs and 2 bolts.
-
Torque:
- 43 N*m{
439 kgf*cm
, 32 ft.*lbf
}
| 2.
INSTALL EXHAUST PIPE ASSEMBLY TAIL |
 |
Install a new exhaust pipe gasket onto the exhaust pipe assembly front.
Install the 2 No. 4 exhaust pipe supports.


Install the exhaust pipe assembly tail with the 2 compression springs and 2 bolts.
-
Torque:
- 43 N*m{
439 kgf*cm
, 32 ft.*lbf
}
| 3.
INSTALL OXYGEN NO. 2 SENSOR
|
 |
- Using SST, install the heated oxygen No. 2 sensor onto the front exhaust pipe.
- SST
- 09224-00010
-
Torque:
- 40 N*m{
408 kgf*cm
, 30 ft.*lbf
}
- HINT:
- Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
- Install the wiring harness clamp bracket.
- Connect the heated oxygen No. 2 sensor connector and engage the 4 clamps.
| 4.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 5.4 N*m{
55 kgf*cm
, 48 in.*lbf
}