REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE OXYGEN NO. 2 SENSOR |
Disconnect the heated oxygen No. 2 sensor connector and disengage the 4 clamps.

Remove the wiring harness clamp bracket.

Using SST, remove the heated oxygen No. 2 sensor.

- SST
- 09224-00010
| 3. REMOVE EXHAUST PIPE ASSEMBLY TAIL |
Remove the 2 bolts and 2 compression springs.


Remove the 2 No. 4 exhaust pipe supports and remove the exhaust pipe assembly tail.
| 4. REMOVE EXHAUST PIPE ASSEMBLY FRONT |
Remove the 2 bolts and 2 compression springs.


Remove the 3 No. 4 exhaust pipe supports and remove the exhaust pipe assembly front.
