2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL HEATED OXYGEN NO. 2 SENSOR

  1. A127391E01
    Using SST, install the heated oxygen No. 2 sensor onto the front exhaust pipe.
    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).

  1. A127390
    Install the wiring harness clamp bracket.

  1. A127389
    Connect the heated oxygen No. 2 sensor connector and engage the 4 clamps.


2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


3. CHECK FOR EXHAUST GAS LEAK
← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →