2005-2008 Yaris · Service Manual ENGINE

REPAIR

Removal / installation · Vehicles built from Nov 2005


1. REPAIR INTAKE VALVE

  1. Repair the intake valve.

    1. A129413E01
      If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.

      NOTICE:
      Releasing the seat-cutter pressure gradually helps to make the valve seat face smoother.

    2. A129414E01
      If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.

      NOTICE:
      Releasing the seat-cutter pressure gradually helps to make the valve seat face smoother.

    3. Check that the seat contact is in the middle of the valve face with the width between 1.0 to 1.4 (0.039 to 0.055 in.)

    4. Hand-lap the valve and valve seat with an abrasive compound.

    5. Recheck the valve seating position.


2. REPAIR EXHAUST VALVE

  1. Repair the exhaust valve.

    1. A129413E01
      If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.

      NOTICE:
      Releasing the seat-cutter pressure gradually helps to make the valve seat face smoother.

    2. A129414E01
      If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.

      NOTICE:
      Releasing the seat-cutter pressure gradually helps to make the valve seat face smoother.

    3. Check that the seat contact is in the middle of the valve face with the width between 1.0 to 1.4 (0.039 to 0.055 in.)

    4. Hand-lap the valve and valve seat with an abrasive compound.

    5. Recheck the valve seating position.

← INSTALLATION (from Nov 2005)COMPONENTS (from Nov 2005) →