2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL STARTER CLUTCH SUB-ASSEMBLY

P024191E01
  1. Apply grease to the steel ball.

  1. Install the ball into the starter clutch assembly.

  1. A128369E01
    Apply grease to the starter idle pinion that is in contact with the starter drive housing.

  1. Install the starter clutch onto the starter drive housing assembly.

  1. Install the 2 starter idle pinions onto the starter drive housing assembly.

  1. B015508E01
    Apply grease to the magnetic switch return spring.

  1. Install the magnetic switch return spring into the starter magnetic switch assembly.


2. INSTALL MAGNET STARTER SWITCH ASSEMBLY

B015490
  1. Install the starter magnetic switch with the 2 bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


3. INSTALL STARTER ARMATURE ASSEMBLY
  1. Apply grease to the bearings.

  1. Install the starter armature into the starter yoke assembly.


4. INSTALL STARTER BRUSH HOLDER ASSEMBLY

B015493
  1. Using a screwdriver, hold the brush spring back, then connect the 4 brushes to the starter brush holder assembly.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.


5. INSTALL STARTER YOKE ASSEMBLY

A117352
  1. Install a new O-ring onto the starter yoke assembly.

  1. Install the commutator end frame with the 2 screws.

    Torque:
    3.8 N*m{ 40 kgf*cm , 34 in.*lbf }

  1. Install a new O-ring onto the starter yoke assembly.

  1. B015509E01
    Align the protrusion of the starter yoke assembly with the groove of the starter magnetic switch assembly. Then install the starter commutator end frame together with the starter yoke assembly.

  1. A117353
    Install the starter commutator end frame and starter stay with the 2 bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →