2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

050 Detection of No Ignition

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
050
The ECU is locked as a result of 10 successive heater ignition failures.
  1. Intake air duct
  2. Exhaust air duct
  3. Fuel pump filter
  4. Heater fuel pump
  5. Combustion heater assembly

INSPECTION PROCEDURE

HINT:
Clear the DTCs by pressing the memory clear buttons on the tester to unlock the ECU.


1. INSPECT INTAKE AIR DUCT
  1. Inspect the intake air duct.

    Result:
    Result
    Proceed to
    There is no problem with the intake air duct.
    A
    The intake air duct is clogged, or other problems are found.
    B



B
CLEAN OR REPLACE INTAKE AIR DUCT
A


2. INSPECT EXHAUST AIR DUCT
  1. Inspect the exhaust air duct.

    Result:
    Result
    Proceed to
    There is no problem with the exhaust air duct.
    A
    The exhaust air duct is clogged, or other problems are found.
    B



B
CLEAN OR REPLACE EXHAUST AIR DUCT
A


3. INSPECT HEATER FUEL PUMP

  1. E124460E03
    Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    1 (+B) - 2 (E2)
    9 to 12 Ω

  1. Inspect heater fuel pump operation.

    1. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, and check the pressure of the hose by hand.

      NOTICE:
      This inspection must be done quickly (within 10 seconds) to prevent damage to the heater fuel pump.

      OK:
      The pressure is applied to the hose.



NG
REPLACE HEATER FUEL PUMP
OK


4. REPLACE FUEL PUMP FILTER
  1. Replace the fuel pump filter with a normal one and check that the condition returns to normal.

    OK:
    The heater is ignited normally and it starts operating.



OK
END
NG

REPLACE COMBUSTION HEATER ASSEMBLY


← 047 Short in Heater Fuel Pump Circuit (+ 048, 049) (from Nov 2005)051 Cold Blow Time Exceeded (from Nov 2005) →