2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

047 Short in Heater Fuel Pump Circuit

Diagnostic trouble codes · Vehicles built from Nov 2005

Also covers:

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
047
A short is detected in the heater fuel pump circuit.
  1. Wire harness or connector between heater fuel pump and combustion heater assembly
  2. Wire harness or connector between heater fuel pump and body ground
  3. Heater fuel pump
  4. Combustion heater assembly
048
Operation stop of the heater fuel pump is detected.
(Open in the circuit)
  1. Wire harness or connector between combustion heater assembly and heater fuel pump
  2. Wire harness or connector between heater fuel pump and body ground
  3. Heater fuel pump
  4. Combustion heater assembly
049
An error is detected in output to the heater fuel pump.
  1. Wire harness or connector between combustion heater assembly and heater fuel pump
  2. Wire harness or connector between heater fuel pump and body ground
  3. Heater fuel pump
  4. Power heater ECU (combustion heater assembly)

WIRING DIAGRAM

E126900E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (COMBUSTION HEATER ASSEMBLY - HEATER FUEL PUMP)

  1. E124458E02
    Disconnect the A52 connector from the combustion heater assembly.

  1. Disconnect the A53 connector from the heater fuel pump.

  1. Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    A52-2 (L) - A53-1 (+B)
    Below 1 Ω
    A52-2 (L) or A53-1 (+B) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (HEATER FUEL PUMP - BODY GROUND)

  1. E124459E03
    Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    A53-2 (E2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT HEATER FUEL PUMP

  1. E124460E03
    Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    1 (+B) - 2 (E2)
    9 to 12 Ω

  1. Inspect heater fuel pump operation.

    1. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, and check the pressure of the hose by hand.

      NOTICE:
      This inspection must be done quickly (within 10 seconds) to prevent damage to the heater fuel pump.

      OK:
      The pressure is applied to the hose.



NG
REPLACE HEATER FUEL PUMP
OK

REPLACE COMBUSTION HEATER ASSEMBLY


← 016 Difference Evaluation 2 (+ 25 more codes) (from Nov 2005)050 Detection of No Ignition (from Nov 2005) →