2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This is power source for the power heater ECU (combustion heater assembly).

WIRING DIAGRAM

E126904E01

INSPECTION PROCEDURE


1. INSPECT FUSE (H-LP CLN/PWR HTR)

  1. E126899E01
    Remove the H-LP CLN/PWR HTR fuse from the engine room R/B and J/B.

  1. Measure the resistance.

    Standard resistance:
    Inspection item
    Specified condition
    H-LP CLN/PWR HTR fuse
    Below 1 Ω



NG
REPLACE FUSE (H-LP CLN/PWR HTR)
OK


2. CHECK HARNESS AND CONNECTOR (POWER HEATER ECU (COMBUSTION HEATER ASSEMBLY) - BODY GROUND)
  1. Remove the power heater ECU (combustion heater assembly).

  1. E124456E10
    Disconnect the A52 connector from the power heater ECU (combustion heater assembly).

  1. Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    A52-1 (E) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (POWER HEATER ECU (COMBUSTION HEATER ASSEMBLY) - BATTERY)

  1. E124456E11
    Measure the voltage.

    Standard voltage:
    Tester connection
    Specified condition
    A52-5 (B) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Power Heater Switch Circuit (from Nov 2005)COMPONENTS (from Nov 2005) →