2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

Power Heater Alternator Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The power heater ECU judges whether the engine is running through the signal it receives from the L terminal of the generator (alternator). Based on that judgement, the ECU determines whether the engine coolant is circulating.

WIRING DIAGRAM

E126901E01

INSPECTION PROCEDURE


1. INSPECT GENERATOR (ALTERNATOR)
  1. Inspect the generator (alternator) (Click herefor ON-VEHICLE INSPECTION, Click here for INSPECTION).



NG
REPLACE GENERATOR (ALTERNATOR)
OK


2. CHECK HARNESS AND CONNECTOR (POWER HEATER ECU (COMBUSTION HEATER ASSEMBLY) - GENERATOR)
  1. Disconnect the A52 connector from the power heater ECU (combustion heater assembly).

  1. E124462E02
    Disconnect the C9 connector from the generator (alternator).

  1. Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    A52-8 (+) - C9-4 (L)
    Below 1 Ω
    A52-8 (+) or C9-4 (L) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (POWER HEATER ECU (COMBUSTION HEATER ASSEMBLY) - BATTERY)
  1. Reconnect the A52 connector to the generator (alternator).

  1. E124456E08
    Measure the voltage.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    A52-8 (+) - Body ground
    Engine is running.
    (Generator (Alternator): Operating)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← 054 High Setting of Flame Cutout (+ 056) (from Nov 2005)Power Heater Fuel Pump Circuit (from Nov 2005) →