2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

Power Heater Fuel Pump Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

When the power heater switch is turned on, the heater fuel pump receives a drive voltage from the power heater ECU (combustion heater assembly). The heater fuel pump provides the combustion heater assembly with fuel necessary for combustion, allowing the combustion heater assembly to operate.

WIRING DIAGRAM

E126902E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (COMBUSTION HEATER ASSEMBLY - HEATER FUEL PUMP)

  1. E124458E02
    Disconnect the A52 connector from the power heater ECU (combustion heater assembly).

  1. Disconnect the A53 connector from the heater fuel pump.

  1. Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    A52-2 (L) - A53-1 (+B)
    Below 1 Ω
    A52-2 (L) or A53-1 (+B) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (HEATER FUEL PUMP - BODY GROUND)

  1. E124459E03
    Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    A53-2 (E2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT HEATER FUEL PUMP

  1. E124460E03
    Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    A53-1 (+B) - A53-2 (E2)
    9 to 12 Ω

  1. Inspect heater fuel pump operation.

    1. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, and check the pressure of the hose by hand.

      NOTICE:
      This inspection must be done quickly (within 10 seconds) to prevent damage to the heater fuel pump.

      OK:
      The pressure is applied to the hose.



NG
REPLACE HEATER FUEL PUMP
OK

REPLACE POWER HEATER ECU (COMBUSTION HEATER ASSEMBLY)


← Power Heater Alternator Circuit (from Nov 2005)Power Heater Switch Circuit (from Nov 2005) →