2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Jan 2006

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


2. REMOVE FRONT DOOR SCUFF PLATE

  1. B134764
    Disengage the 11 claws and remove the front door scuff plate.


3. REMOVE REAR DOOR SCUFF PLATE

  1. B134771
    Disengage the 7 claws and remove the rear door scuff plate.


4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP

  1. B138445
    Detach the front door opening trim weatherstrip sufficiently to remove the upper and lower center pillar garnishes.


5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP

  1. B138446
    Detach the rear door opening trim weatherstrip sufficiently to remove the upper and lower center pillar garnishes.


6. REMOVE CENTER PILLAR LOWER GARNISH

  1. B134767
    Disengage the 3 claws and 2 clips and remove the center pillar lower garnish.


7. REMOVE SEAT BELT ANCHOR COVER CAP

  1. B114421E01
    Pull portion A, shown in the illustration, toward you, remove the 2 claws on the lower side followed by the claw on the upper side. Then remove the seat belt anchor cover cap.


8. REMOVE LAP BELT OUTER ANCHOR COVER

  1. B134891
    Disengage the 3 claws and remove the lap belt outer anchor cover.


9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

  1. B134892
    Remove the bolt and the anchor plate.

  1. B114296
    Remove the bolt and the shoulder anchor.

  1. Disconnect the pretensioner connector.

    1. B134893E01
      Using a screwdriver, release the locking button.

    2. Using a screwdriver, disconnect the pretensioner connector.

  1. B134896
    Remove the 2 bolts, the 2 hooks and the retractor.


10. REMOVE CENTER PILLAR UPPER GARNISH

  1. B134768
    Disengage the 2 clips and 2 hooks and remove the center pillar upper garnish.


11. REMOVE SHOULDER BELT ANCHORAGE PLATE COVER

  1. B134897
    Disengage the 2 claws and remove the shoulder belt anchorage plate cover.


12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

  1. B134898
    Remove the 2 bolts, the hook and the front shoulder belt anchor adjuster.

← COMPONENTS (from Jan 2006)INSTALLATION (from Jan 2006) →