REMOVAL
Removal / installation · Vehicles built from Jan 2006
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).
- NOTICE:
- Always use "Torx" socket wrench E10 when removing the front seat.
- HINT:
- The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).
| 2. REMOVE FRONT SEAT HEADREST ASSEMBLY |
Push in the lock button of the front seat headrest support and remove the front seat headrest.

| 3. REMOVE FRONT SEAT ASSEMBLY |
w/ Front Seat Side Airbag:

Slide the slider and disconnect the airbag connector.
Disconnect the buckle switch connector.
Move the front seat to its most rearward position.

Using "Torx" socket wrench E10, remove the 2 bolts from the front side.
Move the front seat to its most forward position.
Using "Torx" socket wrench E10, remove the 2 bolts from the rear side and the front seat.
