2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2006


1. REMOVE ENGINE UNDER COVER RH

2. REMOVE NO. 2 CYLINDER HEAD COVER

  1. A163755
    Disengage the 2 fittings shown in the illustration.

  1. A163756
    Disengage the 2 fittings shown in the illustration, then remove the No. 2 cylinder head cover.


3. REMOVE FAN AND GENERATOR V BELT

  1. A147659E01
    Loosen bolts A and B.

  1. Turn adjusting bolt C to release the tension and remove the V belt from the pulleys.

  1. Remove the fan and generator V belt.


4. REMOVE CRANKSHAFT PULLEY

  1. A153833E02
    Using SST, hold the pulley in place and loosen the pulley bolt.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A150862E02
    Using SST, remove the pulley bolt and pulley.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)


5. REMOVE TIMING CHAIN OR BELT COVER OIL SEAL

A148114E01
  1. Using a knife, cut off the oil seal lip.

  1. Using a screwdriver with its tip taped, pry out the oil seal.

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

← COMPONENTS (from Nov 2006)INSTALLATION (from Nov 2006) →