INSTALLATION
Removal / installation · Vehicles built from Nov 2006
| 1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH |
Connect the connector and install the rear combination light socket and wire.
| 2. INSTALL REAR COMBINATION LIGHT BULB |
Install the rear combination light bulb (back up light) into the socket and wire.

Turn the rear combination light socket and wire, in the direction indicated by the arrow in the illustration, to install it.
Install the rear combination light bulb (turn signal light) into the socket and wire.

Turn the rear combination light socket and wire, in the direction indicated by the arrow in the illustration, to install it.
| 3. INSTALL REAR COMBINATION LIGHT BODY GASKET LH |
![]() ![]() |
Install a new rear combination light body gasket.
| 4. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH |
Install the tail light (rear combination light) assembly onto the vehicle.

Connect the connector.
Install the 2 nuts.

- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
| 5. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH |
![]() ![]() |
Engage the 6 claws and install the rear combination light service cover.


